Westcoast Saw's Clutch cover provides superior strength, durability, and functionality over the stock cover. Fits exclusively with our 3-point Husqvarna captive nut felling dogs. 

• Made of 6061-T6 Aircraft Aluminum
• Stronger than factory cover
• Larger for better chip management
• Extra large and longer lasting polyurethane chip deflector 
• Wider for ease of walking chain back on without removing cover 
• Field tested to ensure quality
• Bigger in size than the stock cover makes it slightly heavier 
• Includes captive bar nuts, chain slider, and chip deflector
• Made in the USA

All Husqvarna Captive Nut Clutch Covers fit the WCS 3-point felling dogs only. They are not compatible with factory dogs or 4 and 5-points.

Clutch Covers cannot be retrofitted from captive to standard bar nuts. 

If you plan to run a 404 chain, you may need to shave 0.015 (inch) off the chain slider to allow for the additional width.

CHIP DEFLECTOR NOTE

If you purchase a 390/572 clutch cover, use Stihl chip deflector part no. 100-1001.

If you purchase a 365/372/585/592, use Husky chip deflector part no. 100-1012.

INSTALLATION TIP

You will need to remove the chain adjuster rod from your factory clutch cover and install it in the Westcoast Saw cover. If you don't have that piece, contact us for help. See video for detailed installation instructions.

Felling dog bolts need to be installed from the inside of the cover, facing out so that the nut is on the outside of the felling dog. After this, put the cover flat on a table and make sure that you pound the chain sliders down until it stops against the cover - as far as it will go. The clearances are super tight so we get maximum wear out of our chain sliders. Once they are down tight your chain will spin freely. 

Ⓓ CANADA DESIGN REG. NO. 210518, WESTCOAST SAW, LLC